ANNUAL INSPECTIONS

 

ITEMS INCLUDED IN THE FLAT RATE INSPECTION ARE AS LISTED BELOW

 

1 hour of AD research (If more than 1 hour is needed it will be extra)

Clean, gap, test, rotate spark plugs

Pre and Post run up for systems check

Compression check

Servicing battery

Oil and filter change **

Air filter change **

Lubrication and servicing of pulleys, hinges and bell cranks

Cleaning, inspection and repacking of wheel bearings

Landing gear extension/retraction test if required

Mag to engine timing

Removal and installation of inspection panels and interior as necessary for inspection

ELT test and inspection per FAR 91.207 **

Inspection of aircraft

 

Additional items that may be required:

 

Emergency Locator Transmitters (ELTs): ELTs will be inspected at intervals not exceeding 12 months and batteries replaced according to manufacturer recommendations.

 

Fixed Pitch and Ground Adjustable Propellers: Every 5 years the propeller shall be removed from the aircraft and inspected for corrosion or other defects. While the propeller is removed it will be checked for correct dimensions.

 

Altimeter Devices: Altimeters and other Altimetry devices installed in aircraft operating under Instrument Flight Rules, or under visual flight rules in Class B and C airspace or Class C and D airspace that is designated as "Transponder Airspace" shall be calibrated at intervals not exceeding 24 months.

 

(ATC) Transponders: Transponders shall be tested every 24 months.

 

**LABOR ONLY

Any special inspections for continued airworthiness per an installed STC, FAA form 337, Airworthiness Directive, etc. will be charged per hour at normal shop rate. All parts and required repairs are not included in the flat rate and will also be at normal shop rates.